Nanny Care Preparation

  1. Clean everything (bottle, teat and ring) in boiling water for 3 - 5 minutes.
  2. Boil new clean water according to the table below. Do not used microwaved, artificially softened or repeatedly boiled water.
  3. Cool to optimal mixing temperature: 122 F / 50 C.
  4. Fill 2/3 of the bottle with the clean boiled water.
  5. Using the measuring spoon provided and according to the instructions, add the correct number of scoops - normally 1 scoop per 1 fluid ounce of water.
  6. Level off with the back of a clean dry knife. Do not compress the powder.
  7. Close the bottle.
  8. Shake well until dissolved (more than 15 seconds). A small foam later should disappear by itself after a short time.
  9. Add remaining water and shake lightly again until solution is evenly distributed and diluted.
  10. Hold the bottle under cold running water. Cool to drinking temperature: 98.6 F / 37 C.
  11. Always test the temperature.
  12. Ready to feed!